Wan2.1 FusionX LoRA

High-Performance Merged Text-to-Video Model
Built on WAN 2.1 and fused with research-grade components for cinematic motion, detail, and speed — optimized for ComfyUI and rapid iteration in as few as 6 steps.

Merged models for faster, richer motion & detail — high performance even at just 8 steps.

📌 Important: To match the quality shown here, use the linked workflows or make sure to follow the recommended settings outlined below.

🚀 Overview

A powerful text-to-video model built on top of WAN 2.1 14B, merged with several research-grade models to boost:

• Motion quality
• Scene consistency
• Visual detail

Comparable with closed-source solutions, but open and optimized for ComfyUI workflows.

💡 Inside the Fusion

This model is made up of the following which is on TOP of Wan 2.1 14B 720p(FusionX would not be what it is without these Models):

• CausVid – Causal motion modeling for better flow and dynamics
• AccVideo – Better temporal alignment and speed boost
• MoviiGen1.1 – Cinematic smoothness and lighting
• MPS Reward LoRA – Tuned for motion and detail
• Custom LoRAs – For texture, clarity, and small detail enhancements (Set at a very low level)

All merged models are provided for research and non-commercial use only. Some components are subject to licenses such as CC BY-NC-SA 4.0, and do not fall under permissive licenses like Apache 2.0 or MIT. Please refer to each model’s original license for full usage terms.

🚨✨Hey guys! Just a quick update!

We finally cooked up FusionX LoRAs!! 🧠💥
This is huge – now you can plug FusionX into your favorite workflows as a LoRA on top of the Wan base models and SkyReels models!🔌💫 You can still stick with the base FusionX Model if you already use it, but if you would rather have more control over the "FusionX" strength and a speed boost, then this might be for you.

Oh, and there’s a nice speed boost too! ⚡
Example: (RTX 5090)

• FusionX as a full base model: 8 steps = 160s ⏱️
• FusionX as a LoRA on Wan 2.1 14B fp8 T2V: 8 steps = 120s 🚀

Bonus: You can bump up the FusionX LoRA strength and lower your steps for a huge speed boost while testing/drafting.
Example: strength 2.00 with 3 steps takes 72 seconds.
Or lower the strength to experiment with a less “FusionX” look. ⚡🔍

We’ve got:

• T2V (Text to Video) 🎬 – works perfectly with VACE ⚙️
• I2V (Image to Video) 🖼️➡️📽️
• A dedicated Phantom LoRA 👻
  The new LoRA's are HERE Note: The LoRa's are not meant to be put on top of the FusionX main models and instead you would use them with the Wan base models. New workflows are HERE 🛠️🚀